IoT based Finger Print Authentication using Arduino

Project Description:

1. Zigbee: The robot uses Zigbee to establish the connection. It works on 2.4GHz ISM band with 20~250kbits/s data rate and has a transmission range of upto 1.5 km.
2. Arduino Uno: The digital and analog input/output pins are equipped in boards that may be interfaced to various expansion boards and other circuits. Serial communication interface is a feature in this board, including USB which will be used to load the programs from computer.
3. Finger Print Module: This module helps in the identification through fingerprint images. And in general it can be split up into the following tasks, finger print scanning-finger print classification-finger print comparison. During the classification process, finger print images are optionally allocated to a certain category based on the global orientation of the ridges while the location of the minutiae is marked as well. The comparison is divided into the following six steps,
• Scanning of a finger print image: The quality of the scanned finger print image is the decisive factor for the identification purpose. This can be achieved by using a high-definition finger print scanner which can tolerate the skin types, colours, damages and dryness factors.
• Image quality improvement: Here an optical improvement is applied to the structure on the scanned finger print image
• Image processing: This is the preparatory phase for the feature extraction and classification purposes
• Feature classification: All the finger prints show certain global similarities facilitating a rough classification. There are 3 principal finger classes exist. In this process the image is classified under anyone of the principal classes.
• Feature extraction: In this process the location of the minutiae (ridge bifurcation & ridge endings) in the finger print is detected and extracted. At real time, the quality of the finger print image impacts this process a lot. So proper care should be taken to avoid the negative influence caused due to poor quality image.
• Verification process: In this process two features are compared. The algorithm functioning strongly depends on the quality of the extracted minutiae and the comparison image.

Project Implementation:

1. First, the finger print of the users should be stored in the server to recognize the user. You can program the system in such a way that whenever you press ‘E’ the enrolment action will be activated. And then the finger print of any user can be stored.
2. During the authentication or attendance process, you can press the ‘ST’ button to start the process. A green LED glows and indicates the status of the system. Then the handheld device can used for the authentication purpose.
3. And once the authentication process is done you can press ‘SP’ button to stop the process and the green LED will stop glowing.
4. The finger print modules is connected to Arduino and the serial communication is done through the ZigBee module (if the data needs to be sent to a device for storage and analysis purpose)

Software requirements:

1. You will be needing Arduino IDE software to write and upload the programming logic onto the Arduino Uno board

• arduino
• zigbee
• biometrics

• iot
• Authentication systems